Home > News > Content

Automatic Blow Molding Machine Frequently Asked Questions

May 27, 2017

  Automatic Blow Molding Machine For the blow molding machine, many new people into the plastic bottle industry, before the purchase, the need to understand and learn a lot of knowledge, need to buy according to their own needs. The more expensive blow molding machine is naturally the better, but not necessarily for you. Because the late-stage production process will also involve a lot of factors, only to find the right to play the greatest use, to produce the best benefits.

   Automatic Blow Molding Machine For some large drinks, mineral water or cosmetics and other manufacturers, because the use of a large amount of packaging, often with the product filling one, this type of blow molding machine should choose fully automatic, high-speed, stable and reliable quality blowing Machine, only such a blow molding machine will not be in the latter part of the production process affect the other links, affecting the overall production efficiency. For some small and medium-sized manufacturers can consider semi-automatic, two-step blowing machine, on the one hand can reduce the cost of the first purchase of blow molding machine required, on the other hand, such blow molding machine production capacity is relatively low Some, more in line with the needs of manufacturers. Because the blow molding machine to produce plastic bottles are hollow products, if a large number of piling, will give the formation of a lot of pressure on the warehouse. For some personal or family workshops, the beginning can be considered the use of second-hand blow molding machine, this type of blow molding machine prices are relatively low, as long as the understanding of all aspects of the parameters, then buy, or there are many cost-effective machines worth choosing.

   Automatic Blow Molding Machine  Blowing machine blowing process in the process of common problems

1, the old card into the feed tray: This situation is a headache problem, from the experience point of view if the length of the preform (embryo) relatively long cut the weight of the larger, then this phenomenon is relatively small.

2, if not: Please check the control of the hoist contactor is in the state of the power supply, if the feed is not expected: 1), whether the hopper has been expected, if it is: need to quickly feeding; If it is energized, quickly check whether the motor is in power and load state, because this situation is likely to be preformed by the preform (embryo) to lift the belt, then the easiest way is to help manually upgrade; 3) If the control contactor of the elevator is not in the active state, check that the preform is not on the same straight line as the reflector.

3, the bottle is always stuck in the position of the robot is dislocation.

4, the bottle can not be removed from the mold after blowing out.

First of all, the mold should be opened, manually open and close the mold, if normal, run in the empty state of operation, if it is normal.

Please check your exhaust time setting, if the exhaust is set properly, and each time as long as a blow on the failure, then you can determine the exhaust valve problem, please open the exhaust valve to check the spring and seal (this There is a phenomenon that the exhaust sound is relatively large or no row of the sound of the net).

If you are experiencing a lot of mold production is normal to come about this kind of open can not mold the situation, please check whether the lock pin pin in the inside of the screw, please check the clamping force is too large, if too much should be in accordance with Standard readjustment.

5, two robots collide: This situation requires a manual reset robot, is caused by dislocation.