Blow Molding Machine Maintenance And Maintenance
Blow Molding Machine Maintenance and maintenance
Blow molding machine can blow the machine oil pot, jug, soy sauce pot and other products, that hydraulic blow molding machine maintenance and maintenance we know how much, the following told you to explain the hydraulic blow molding machine maintenance and maintenance, hoping to help To everyone, if there are other problems can also call our phone.
1, feeding level without feeding: need to check several cases,
Whether the hopper has been expected, if it is: need to quickly feeding
No: Please check the hydraulic blow molding machine to control the contactor is in the state of power, if it is energized, quickly check whether the motor is in power and load state, because this situation is likely to be preform (embryo) stuck Lift the belt, then the easiest way is to help manually upgrade. If you check the hydraulic blow molding machine control contactor is not in the state of power, please check the preform to see whether the electric eye and the reflector is not in the same straight line.
2, the old card into the feed tray: This situation is a headache problem, from the experience point of view if the length of the preform (embryo) relatively long cut the weight of the larger, then this phenomenon is relatively small.
3, the bottle can not be taken out from the mold after blowing.
First of all, the mold should be opened, manually open and close the mold, if normal, running in the air running state, if it is normal.
Please check your exhaust time setting, if the exhaust is set properly, and each time as long as a blow on the failure, then you can determine the exhaust valve problem, please open the exhaust valve to check the spring and seal (this There is a phenomenon that the exhaust sound is relatively large or no row of the sound of the net).
If you are experiencing a lot of mold production is normal to come about this kind of open can not mold the situation, please check whether the lock pin pin in the inside of the screw, please check the clamping force is too large, if too much should be in accordance with Standard readjustment.
4, the bottle is always caught injury
Whether the position of the robot is dislocated.
5, two robots collide
This situation requires a manual reset of the robot, which is caused by dislocation
This machine with cladding, liquid level line can blow 5L the following products such as oil jug, jug, soy sauce pot and other products. The use of hydraulic systems, computer control, double-bit blowing, quality and stability.
In our lives for the use of plastic bottles is very much, not only in the drink we need to use the plastic bottles and in other industries and fields will also use a lot of plastic bottles or plastic containers, plastic containers not only Light weight, and easy to carry, widely used by people, but these plastic containers are used in the production of blow molding machine is used to blow, mainly through the use of plastic particles or do the preform, etc., after A certain craft means to blow the shape of the bottle that people need, so that people can be widely used in life or other areas, the main products of the blow molding machine equipment features are:
1, plastic hollow containers have been people use a lot of a product, not only because the plastic with light and cheap, high security performance advantages, and many people often choose to use plastic containers instead of glass containers in full bloom Different products.
2, Blow Molding Machine is mainly used in oil-free balloon clamping technology to produce plastic bottles and plastic containers, not only clamping force, and the elbow run into less force, long life, but also the use of flying out of the patented technology , So that the plastic container has a better sealing performance.